107
MR-8mkII Owner’s Manual (Part data editing)
6) Rotate the JOG dial to select "Source Track = *",
and press the [MENU/ENTER] key.
The display now shows the screen for
selecting the copy source track(s).
You can select the copy source track(s) by
rotating the JOG dial.
The available options are:
• 1 through 8 (mono track)
• 1/2, 3/4, 5/6 and 7/8 (stereo tracks)
7) Rotate the JOG dial to select the source track(s)
to be copied, and press the [MENU/ENTER]
key.
You can select the destination track(s) by
rotating the JOG dial.
The available options are:
• 1 through 8 (mono track)
• 1/2, 3/4, 5/6 and 7/8 (stereo tracks)
<Note>:
You cannot select the same track(s)
for the copy source and destination.
5) Rotate the JOG dial to select "Copy-PastePart >",
and press the [MENU/ENTER] key.
The display now shows the screen for
selecting the source track(s) and destination
track(s) of copy/paste. "<<Back" is initially
highlighted.
9) Rotate the JOG dial to move the cursor to
"[ENTER]" at the bottom of the screen,
then press the [MENU/ENTER] key.
The display shows "Please Wait", immediately
followed by "Completed" when the MR-8mkII
completes the copy/paste operation.
8) Rotate the JOG dial to select the destination
track(s), and press the [MENU/ENTER] key.
The display returns to the previous screen.
4) Rotate the JOG dial to select "Part Edit >", and
press the [MENU/ENTER] key.
The display now shows the part edit menu
screen, where "<< Back" is highlighted.
To cancel the copy/paste operation, move the
cursor to "[CANCEL]" at the bottom of the
screen, and press the [MENU/ENTER] key.
flashing
flashing
flashing
flashing
To Next Page
Loading...
Need help?
General
