EasyManuals Logo

Fostex MR8 Mk2 User Manual

Fostex MR8 Mk2
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
49
MR-8mkII Owner’s Manual (Advanced playback and locate functions)
When the loop mode is active (while the auto punch in/out mode is inactive), the LOCATE
A and LOCATE B points are used as the loop start and end points. When the auto punch in/
out mode is active (while the loop mode is inactive), the LOCATE A and LOCATE B points
are used as the punch-in and punch-out points.
When both the auto punch in/out and loop modes are active, the LOCATE A and LOCATE
B points are used as the punch-in and punch-out points, while the loop function starts at
"the LOCATE A point minus the pre-roll time" and ends at "the LOCATE B point plus the
post-roll time, as shown below. The pre-roll time is initially set to four seconds, while the
post-roll time is set to one second.
Using the loop function in the auto punch in/out mode reduces the number of key presses,
allowing you to concentrate on playing.
LOCATE A point
LOCATE B point
4 sec.
1 sec.
LOOP START point
LOOP END point
LOCATE A point
(Punch in point)
LOCATE B point
(Punch out point)
LOOP START point
LOOP END point
You can change the pre-roll and post-roll time within the range between 0.1 and 10.0
seconds (in 0.1 second steps) in the menu mode (see page 134).
<Note>:
If you set the LOCATE A point to the beginning of a song (ABS ZERO) or set the
LOCATE B point to the recording end point (REC END) of a song, the pre-roll or post-roll
time is ignored.
Loop function in auto punch in/out mode

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fostex MR8 Mk2 and is the answer not in the manual?

Fostex MR8 Mk2 Specifications

General IconGeneral
BrandFostex
ModelMR8 Mk2
CategoryRecording Equipment
LanguageEnglish

Related product manuals