Fostex MR8 Mk2 User Manual

141
MR-8mkII Owner’s Manual (Troubleshooting)
<Trouble 9>: I cannot execute auto punch in/out.
• Is "
" shown on the screen?
If it is not, press the [AUTO PUNCH] key to make the
auto punch in/out function active.
• Are the punch-in and punch-out points set cor-
rectly?
To check each point, press the [LOCATE A/IN] or [LO-
CATE B/OUT] key. The recorder locates to the punch-
in or punch-out point, while the screen shows the ap-
propriate time data.
If the punch-out point is earlier than the punch-in point,
set these points appropriately so that the punch-in point
is earlier than the punch-out point.
<Trouble 1>: During playback, the recorder suddenly
executes locating.
• Is "
" or " " shown on the dis-
play?
If so, the play mode is set to the auto return or loop
mode. Press the [PLAY MODE] key until "Off" is se-
lected.
<Trouble 2>: Cannot monitor the playback sound.
• Are the track fader(s) for the playback track(s) and
the [MASTER] fader brought up to the appropriate
positions?
Raise the fader(s) for the track(s) you want to monitor,
as well as the [MASTER] fader.
If you monitor via headphones, also raise the [PHONES
VOL] control.
<Trouble 3>: I press the [PLAY] key while holding down
the [STOP] key, but I cannot execute loop playback.
• Are the LOCATE A and LOCATE B points set cor-
rectly?
By default, both of these points are set to the beginning
of a song (i.e. "0m00s000ms" or "-2bar 1beat 00clk").
In this condition, you cannot execute loop playback.
Also, if the LOCATE B point is earlier than the LOCATE
A point, you cannot execute loop playback.
Troubles for playback
<Trouble 1>: I cannot apply the effects.
• Are the [EFFECT SEND] control for the track
you want to apply the effect and track fader
raised appropriately?
Raise the [EFFECT SEND] control(s) for the track(s)
(1 through 4) you want to apply the effect to send
signal(s) to the internal digital effects.
Also, make sure that the fader(s) for the track(s)
you want to apply the effect is(are) raised.
010
EFFECT SEND
100100100
<Trouble 2>: I cannot apply the mic simulation effects.
• Is the [INPUT A SELECT] switch on the rear
panel is set to "MIC/LINE" position?
To apply the mic simulation effects to [INPUT A], the
[INPUT A SELECT] switch on the rear panel must
be set to "MIC/LINE" position.
When you set the switch to any other position, you
can use the amp simulation effects for insert effects.
INPUT A SELECT
INT MIC
GUITAR
MIC/LINE
Troubles for effect

Fostex MR8 Mk2 Specifications

General

Brand	Fostex
Model	MR8 Mk2
Category	Recording Equipment
Language	English