106
MR-8mkII Owner’s Manual (Part data editing)
You can copy the desired part(s) of the selected track(s) and paste it(them) to the same time
position of the other desired track(s). The copy/paste operation of a part or parts can be made
only within the current song. You can also make the copy/paste operation of a part or parts
using another method described later in "Copying/pasting the desired part(s) (2)".
TRK 1
TRK 2
TRK 3
TRK 4
TRK 5
TRK 6
TRK 7
TRK 8
LOCATE A
point
LOCATE B
point
<Note>:
You cannot copy/paste track data of a song
protected. Release the protection before making
the copy/paste operation.
<Note>:
If you want to paste the copied part(s) to
the desired time position of other track(s) other
than the position between the LOCATE A and LO-
CATE B points, use the method described later in
"Copying/pasting the desired part(s) (2)".
9) Press the [MENU/ENTER] key.
The display now returns to the part edit menu
screen, where “Erase Part >” is highlighted.
10) Press the [STOP] key to exit the menu mode.
8) Rotate the JOG dial to move the cursor to
"[ENTER]" on the screen, and press the
[MENU/ENTER] key.
The display shows "Please Wait", immediately
followed by "Completed" when the MR-8mkII
completes erasing.
If you want to cancel the part erase operation,
move the cursor to "[CANCEL]" on the screen,
and press the [MENU/ENTER] key.
Copying/pasting the part(s)-1
1) Load the song you want to edit.
2) Set the LOCATE A and LOCATE B points for
specifying the desired part(s) (see page 51).
You can check the part(s) by playing back
between the LOCATE A and LOCATE B points
(see page 46).
3) While the recorder is stopped, press the
[MENU/ENTER] key to enter the menu mode.
The display now shows the first page of the
menu selection screen, where "<< Back" is
highlighted initially (selecting "<< Back"
returns to the previous screen).
flashing
To Next Page
Loading...
Need help?
General
