133
MR-8mkII Owner’s Manual (Other functions)
The level meters shown on the display have the peak hold function. When it is enabled, the
meter peak value during recording is held for the specified time.
The default meter peak hold time is three seconds. You can disable the peak hold function or
change the peak hold time.
1) While the recorder is stopped, press the
[MENU/ENTER] key to enter the menu mode.
The display now shows the first page of the
menu selection screen, where "<< Back" is
highlighted initially.
2) Rotate the JOG dial to select "System", and press
the [MENU/ENTER] key.
The display now shows the first page of the
system menu screen, where "<< Back" is
highlighted initially.
3) Rotate the JOG dial to select "PeakHold Time"
on the second page and press the
[MENU/ENTER] key.
The currently selected peak hold time (by
default, "3s") flashes.
You can now make the desired peak hold
setting.
4) Rotate the JOG dial to select the desired hold
time, and press the [MENU/ENTER] key.
The peak hold setting is confirmed and the
display returns to the previous screen.
5) Press the [STOP] key to exit the menu mode.
The peak hold setting is effective to all songs.
You can select from "3s" (3 seconds, default),
"1s", "2s", "4s", "5s" and "Off".
When "Off" is selected, the peak hold function
is disabled (the peak value is not held).
Peak hold indication
By default, it is held for three
seconds.
Peak hold time setting
flashing
To Next Page
Loading...
Need help?
General
