55
MR-8mkII Owner’s Manual (Punch in/out)
2) Press the [REC SELECT] key for the track you
are going to make punch in/out recording.
The track is record-armed.
3) Locate the recorder to the point before the punch-
in point, and press the [PLAY] key to start play
back.
It may be a good idea to play the instrument
along with the playback sound, so that you can
get the tempo and feel.
You can make hands-free punch in/out recording using an unlatched-type footswitch.
POWER USB FOOT SW
ON
DC IN
LIGHT
OFF
12V
<Note>:
You cannot perform another punch
in/out recording successively.
To perform punch in/out recording in an-
other part, stop the recorder and perform
the steps above again.
Unlatched-type
footswitch
6) Press the [STOP] key to stop the recorder.
7) Rewind the recorder and play back the part you
performed the punch in/out recording to check
the result.
If you are not satisfied with the result, use the
undo function to cancel the punch in/out
recording and try again.
Press the footswitch.
(Punch in)
Playback
Recording
Playback
Press the footswitch.
(Punch out)
Punch in/out using the footswitch
MAX
MIN
MAX
MIN
REC SELECT
1 2 3 4 5/6 7/8 MASTER
RL
PAN
LR LR LR
010
EFFECT SEND
100100100
BRIT STACK US METAL 60'S COMBO
MIC
TUBECONDENSERDYNAMIC
INPUT A
LINE
MIC
MIN
MAX
LINE
MIC
DISTORTION
GUITAR
UNBAL
BAL
UNBAL
/GUITAR
PEAK
TRIM
TRIM
BAL
INPUT A INPUT B
PHONES VOL
L
ST OUT
R
2
PHONES
1
MIN
MAX
EFFECT
REVERB/DELAY TIME
MIN MAX
HALLROOM
PLATE DELAY
LOCATE REC END
A-B PLAY
LOCATE ABS ZERO
DELETE+-_0YZ9VWX8STU7
PLAYSTOPRECORD REWIND F FWD
PQR6
UNDO/REDO
PLAY MODE
STORE
A / IN B / OUT
LOCATE
MNO5JKL4
BRIGHTNATURALPOWERFUL
MENU/ENTER
MASTERING
GHI3DEF2ABC1
7/8
WAV FILE
STEREO
1-4
1-6
NEW
SONG
1-8
GUIDE
RHYTHM
CONTRAST
TIME BASE
SELECT
BOUNCE
INPUT A SELECT
AUTO PUNCH
5/6
7/8
AMP SIMULATION
MIC SIMULATION
PEAK
2
4,5
3,7
6
[FOOT SW] jack
1) Connect the footswitch to the [FOOT SW] jack
on the MR-8mkII rear panel.
4) When the recorder reaches at the point you want
to punch in, press the footswitch.
The armed track is punched in (i.e. starts
recording).
5) When the recorder reaches at the point you want
to punch out, press the footswitch again.
The recorder status switches from recording
to playback.
To Next Page
Loading...
Need help?
General
