98
MR-8mkII Owner’s Manual (Track data editing)
9) Press the [MENU/ENTER] key.
The display now returns to the track edit menu
screen, where “Copy-Paste Trk >” is highlighted.
10) Press the [STOP] key to exit the menu mode.
<Note>:
If a destination track has recorded
data, pasting the copied data overwrites the
previous data.
<Note>:
If you want to cancel the copy/paste
operation, move the cursor to "[CANCEL]"
on the screen, and press the [MENU/ENTER]
key.
<Note>:
If you are not satisfied with the re-
sult, press the [UNDO/REDO] key to undo
the operation (see page 95).
5) Rotate the JOG dial to select "Source Track = 10º",
and press the [MENU/ENTER] key.
You can now select the desired copy source
track(s) by rotating the JOG dial.
The available options are:
• 1 through 8 (mono track)
• 1/2, 3/4, 5/6 and 7/8 (stereo tracks)
7) Rotate the JOG dial to select the destination track(s),
and press the [MENU/ENTER] key.
“Dest. Track = *” is now highlighted on the
screen.
<Note>:
You cannot select the same track(s)
for the copy source and destination.
8) Rotate the JOG dial to move the cursor to
"ENTER" at the bottom of the screen, then press
the [MENU/ENTER] key.
The display shows "Please Wait", immediately
followed by "Completed" when the MR-8mkII
completes the copy/paste operation.
You can select the same number of tracks as
the copy source track(s). For example, if you
select a mono track for the source, you can
only select a mono track for the destination.
6) Rotate the JOG dial to select the source track(s)
to be copied, and press the [MENU/ENTER] key.
You can now select the desired copy
destination track(s)
flashing
flashing
flashing
flashing
To Next Page
Loading...
Need help?
General
