Fox Thermal FT3 - Page 100

F1 F2 F3 F4
Press NXT (F1) repeatedly until the correct selection is shown and then press OK (F4) to accept the
setting.
Selections are: NONE
ODD
EVEN
F1 F2 F3 F4
Press CHG (F1) to change the address and then press OK (F4) to accept the setting.
Selections are between 01 and 247.
NOTE! Power cycle is required for the new settings to take eect.
Parity=EVEN
NXT OK
Address=02
CHG OK
Communications | 100
Model FT3
Communications