Fox Thermal FT3 - Agency Approvals

Agency Approvals
CE: Approved
EMC Directive; 2014/30/EU
Electrical Equipment for Measurement, Control and Lab Use: EN61326-1:2013
Low Voltage Directive (LVD): 2014/35/EU
Product Safety Testing: EN 61010-1: 2010
Pressure Equipment Directive: 2014/68/EU
Weld Testing: EN ISO 15614-1 and EN ISO 9606-1, ASME B31.3
FM and FMc: Approved
Class I, Division 1, Groups B,C,D;
Class II, Division 1, Groups E,F,G;
Class III, Division 1; T3C, Ta = - 40˚C to +70˚C;
Class 1, Zone 1, AEx/Ex d IIB + H2 (T6, T4, or T1*); Ta= -20˚C to +70˚C; Type 4X (IP67)
ATEX (FM12ATEX0034X): Approved
II 2 G Ex db IIB + H2 (T6, T4, or T1*) Gb Ta = - 20˚C to +70˚C; IP67
II 2 D Ex tb IIIC (T85˚C, T135˚C, or T450˚C*) Db Ta = - 20˚C to +70˚C; IP67
IECEx (IECEx FMG 12.0010X): Approved
Ex db IIB + H2 (T6, T4, or T1*) Gb Ta = - 20˚C to +70˚C; IP67
Ex tb IIIC (T85˚C or T135˚C*) Db Ta = - 20˚C to +70˚C; IP67**
ATEX and IECEx Standards:
EN 60079-0 EN 60079-31 IEC 60079-0 IEC 60079-31
EN 60079-1 EN 60529 +A1 IEC 60079-1 IEC 60529
Model Code Temp. Code Marking - Zones (Gas) Temp. Code Marking - Zones (Dust)
Enclosure Sensor Type Main Enclosure Remote Enclosure Main Enclosure Remote
Enclosure**
E1 ST T4 N/A 135°C N/A
E2 ST T4 N/A 135°C N/A
E3 ST T6 T4 85°C 135°C**
E4 ST T6 T4 85°C 135°C**
E3 HT T6 T1 85°C 450°C**
E4 HT T6 T1 85°C 450°C**
*Temperature code ratings for Zones are dependent on external process temperature factors and equipment enclosure
conguration. See the table above for specic temperature code ratings.
**The IECEx dust rating does not apply to the Remote Enclosure.
Specic Conditions of Use:
1. The ameproof joints of the equipment are not intended to be repaired. Consult the manufacturer
if dimensional information on the ameproof joints is necessary.
2. Refer to the manufacturer’s instructions to reduce the potential of an electrostatic charging hazard
on the equipment enclosure.
Appendix | 125
Model FT3
Appendix