Fox Thermal FT3 - Installation; General Precautions

Installation Scope
This section describes how to install the Fox Thermal model FT3 Flow Meter and how to get started.
Installation methods will vary according to the ow meter type (insertion or inline).
For Insertion Types:
1. Determine lateral position on the pipe.
2. Determine radial position of probe if moisture or condensation present in the gas.
3. Sensor installation depth.
4. Sensor orientation in relation to sensor length and direction of ow.
5. Proper tightening of compression tting for mounting meter.
For Inline Types:
1. Determine lateral position on the pipe.
2. Flow body orientation in relation to direction of ow in pipe.
3. Proper tightening of compression tting.
Installation procedures must be performed using a combination of the end user’s best engineering
practices, in compliance with local codes, and with manufacturer’s recommendations.
General Precautions
The following general precautions should be observed:
1. Exercise care when handling the ow meter to avoid damaging the probe, sensor or
enclosure.
2. Close any unused conduit openings in the enclosure with plugs certied for your
application.
3. The enclosure cover must be closed except during conguration or during installation.
4. Mounting FT3 in direct sunlight can cause the temperature inside the enclosure to increase
beyond design limits, resulting in failure of LCD display and reduced component life. It
is recommended that a sunshade be installed to avoid direct sunlight (see maximum
enclosure operating temperature specication).
5. Ensure the ow direction indicator points in the direction of ow.
6. Do not install the FT3 enclosure near an igniter, igniter-controller or switching equipment.
7. Do not install an external power supply in a cabinet containing an igniter controller or
switching equipment.
8. For accurate ow measurement, review ow meter placement instructions before
installation to ensure a proper ow prole in the pipe.
9. For safety reasons, Teon ferrules are only appropriate for applications with pressures of 60
psig or less. At higher pressures, use of a Teon ferrule risks unwanted probe movement
or ejection of the probe from the pipe. For all applications above 60 psig, the standard
stainless steel ferrule is required.
Installation | 20
Model FT3
Installation