Data Logger | 108
Model FT3
Data Logger
Model FT3
Setting the Start/Sync Time
The start/sync time is used to start or syncing a data log sample. When a match is detected between
the real time clock and the start/sync time, the interval is reloaded. The Data Logger will be set to the
default of zero (midnight) and only the hour, minute, and second will be used for the trigger.
For example:
A settting of "day=00, hour=00, minute=00" will reload the interval every day at midnight.
From the data log menu, press F2 (STR). The screen will show:
F1 F2 F3 F4
Press F1 (NXT) to turn ON or OFF the Start/Sync Time and then press F4 (OK):
F1 F2 F3 F4
Press F4 (OK).
F1 F2 F3 F4
Set the hour for which you want to start/sync time. When the Hour Start is set to zero, the default will
be for midnight. Press F4 (OK).
F1 F2 F3 F4
Set the minute for which you want to start/sync time. Press F4 (OK).
F1 F2 F3 F4
Start Time = ON
NXT OK
Day Start = 0
CHG OK
Hour Start = 0
CHG OK
Min Start = 0
CHG OK
Set Start Time?
YES OK
To Next Page
Loading...
