Fox Thermal FT3 - Introduction; FT3 Menu Tree - Main Menu

SET PARAMETERS
I/O FLO DSP EXIT
SET I/O
COM I/O 420 EXIT
Comm=Modbus
NXT OK
None
Modbus
HART
SET I/O
INP OUT EXIT
INP= Not used
NXT OK
Not used
Tot Reset
SET 4-20 mA
CH1 CH2 EXIT
20 mACnt=3265
CHG OK
4 mACnt=367
CHG OK
20 mA=2345.6 SCFM
CHG OK
4 mA=0 SCFM
CHG OK
CH2=Temp
NXT OK
Temp
Flow
20mACnt=3748
CHG OK
4mACnt=274
CHG OK
20 mA=300 °F
CHG OK
4 mA=0 °F
CHG OK
Level 2
password
Level 2
password
Analog Outputs
Select either flow
or temperature for
channel 2
Baud=9600
NXT OK
Parity=EVEN
NXT OK
Address=02
CHG OK
Modbus
only
1200
2400
4800
9600
19200
NONE
ODD
EVEN
01-247
Enter menu by scrolling to display 6
and entering the password
mA Fault=Not use
NXT OK
Not use
3.6 mA
21 mA
LOG
NOTE! Some menus will only be available with a level 2 password.
NOTE! Menu tree boxes are populated with example values.
Display Menu, p. 12
Flow Parameter Menu 1, p. 10
Digital Output Menu, p. 9
Data Log Menu, p. 14
Model FT3
Introduction | 8
Introduction
Fig. 1.1: FT3 Menu Tree - Main Menu