Fox Thermal FT3 - Page 105

Common-Practice Commands, Unsupported Commands
Burst Mode - This device does not support Burst Mode.
Catch Device Variable - This device does not support Catch Device Variable.
Device-Specic Commands - No Device-Specic commands are implemented.
Modes
Fixed current mode is implemented, using Command 40. This mode is cleared by power loss or reset.
Damping
Damping is standard, aecting only the PV and the loop current signal.
Capability Checklist
Communications | 105
Model FT3
Communications
Manufacturer, model Fox Thermal Instruments, FT3
Device Type Transmitter
HART revision 7.1
Device Description available No
Number and type of sensors 1
Number and type of actuators 0
Number and type of host side signals 1 : 4-20mA analog
Number of Device Variables 0
Number of Dynamic Variables 4
Mappable Dynamic Variables No
Number of common-practice commands 17
Number of device-specic commands 0
Bits of additional device status 8
Alternative operating modes No
Burst mode No
Write-protection Yes