Fox Thermal FT3 - Page 52

FT3 Engineering Displays
Pressing the F1 and F2 keys at the same time in the normal mode brings up the engineering displays.
These displays show internal parameters of the FT3 which are used by Fox Thermal service technicians.
Use the F1 and F2 keys to navigate. Press F4 to exit.
There are nineteen (19) screens (10 - 28) to view meter data:
Screen 10 - Flow rate measured by the meter, CSV of the sensor measurement circuit.
Screen 11 - Average CSV of the sensor measurement circuit, velocity ow in user-selected unit.
Screen 12 - Sensor ltered average voltage, velocity in meter/hour.
Screen 13 - TSI average count, TSV average count.
Screen 14 - TSI in volts, TSV in volts.
Screen 15 - TSI current in Amp, TSI resistance in ohm.
Screen 16 - RTD9 count, gas temperature in degrees C.
Screen 17 - Channel 1 4-20mA current loop count, channel 2 4-20mA current loop count.
Screen 18 - Frequency output count, active alarm codes.
Screen 19 - High and low ow alarm settings.
Screen 20 - High and low temperature alarm settings.
Screen 21 - Elapsed time of meter operation and the status in hexadecimal.
Screen 22 - FT3 electronics rmware version, optional display rmware version.
Screen 23 - Total number of power cycles, number of errors in total ow measurement.
Screen 24 - TSI resistance in ohm, RTD9 resistance in Ohm.
Screen 25 - Most recent CAL-V™ value, CAL-V™ last verify value.
Screen 26 - Bridge shutdown detection count.
Screen 27 - Zero CAL-CHECK™ pipe reference value, most recent Zero CAL-CHECK™ test difference.
Screen 28 - Zero CAL-CHECK™ bottle reference value, most recent Zero CAL-CHECK™ test difference.
Operation | 52
Model FT3
Operation