FP Postbase Mini - Cleaning the Print System; 12.5.1 Starting Automatic Print System Cleaning

Maintenance and care
73
12.5 Cleaning the print system
12.5.1 Starting automatic print system cleaning
You should start automatic print system cleaning only if the print quality is not good
enough (e.g. blank spots in the imprint after longer periods out of use).
Cleaning
• Open the M
ENU.
• Select P
RINT SYSTEM.
• Select C
LEANING.
A message informs you about the cleaning
process in progress.
• Check the print quality with a test print.
Intensive cleaning
• Open the M
ENU.
• Select P
RINT SYSTEM.
• Select I
NTENSIVE CLEANING.
A message informs you about the cleaning
process in progress.
• Check the print quality with a test print.
In case of stubborn soiling, even intensive
cleaning may be unable to improve the print
quality as desired. In such cases, you can
manually clean the cartridge (see page 74).