Fractal FM3 - Page 103

97
13 SETUP MENU
MIDI/REMOTE: MAPPING PAGE
With PC Mapping enabled (see above), incoming Program Change messages are re-mapped according to the
values in the table in this section.
PARAMETER Description
Map to Preset
Map to Scene
When PC Mapping (above) is turned “ON”, the parameters in this table specify
which preset and scene are loaded for each incoming MIDI PC message.
See also "Program Change Mapping" on p. 53
MIDI/REMOTE: BYPASS PAGE
The Bypass page of the MIDI menu allows you to map MIDI CC messages—or connected pedals and switches—
to bypass or engage blocks. CC messages can be sent by a MIDI controller or computer connected to the MIDI
IN jack. Each of these settings is global. In every case, the method for mapping a controller to one of these
functions is the same:
1. Use the NAV knob to select the desired function.
2. Use the VALUE knob to assign a controller to the function:
 Select "NONE" to remove all assignments from the selected item.
 The following assignments work with a pedal or switch connected
to the on-board expression jacks of the FM3:
 PEDAL 1 or 2 (EXP/SW TIP) - for an expression pedal or a switch connected to the tip of a TRS cable.
 PEDAL 1 or 2 (SW RING) - for an external switch connected to the ring of a TRS cable.
 FC__ PEDAL 1–4 to assign a pedal connected to the corresponding pedal jack of the designated FC controller.
 FC__ SW 1–4 to assign a switch connected to the corresponding switch jack of the designated FC controller.
 1—127 to assign a MIDI CC#.
MIDI/REMOTE: CHANNEL PAGE
The Channel page works exactly like the Bypass page except the entries are used to set the Channel of each
block instead of its bypass state. The value of the CC message sets the channel as follows:
0 = Channel A 1 = Channel B 2 = Channel C 3 = Channel D
The series continues, repeating A, B, C, D for values up to 127 (D).
For additional information, see "Selecting Scenes & Channels Remotely" on p. 52
MIDI/REMOTE: EXTERNAL PAGE
Controller assignments for the sixteen External Controllers used in Modiers (See Section 9: Modiers).
MIDI/REMOTE: LOOPER PAGE
Controller assignments for the functions of the Looper.