5
Backing up light:P21W
6
Rear foglight (driver's side): P21W
7
License plate lamp: R5W
Replacing the taillamps on the chassis
Requirements:
R
Rear foglights: bulb type P21W
R
License plate lighting: bulb type R5W
R
Backing up lights: bulb type P21W
R
Turn signal lights: bulb type PY 21 W
R
Clearance lamps: bulb type R5W
R
Brakelights: bulb type P21W
R
Tail lights: bulb type R5W
1
Light lens
2
Screws
3
Rear foglight
4
License platelamp
5
Backing up light
6
Turn signal light
7
Clearance lamp
8
Brakelight
9
Tail light
#
Switch offthe lighting system.
#
Unscrew screws 2 and remove light lens
1.
#
Remove theplug from thebulb mount.
#
Gentlyturnthe bulb counter-clockwise and
take it out of thesocket.
#
Insert thenew bulb intothe socketand turnit
clockwise.
#
Position light lens 1 and tighten screws 2.
Replacing interiorlight bulbs
Replacing rear interior lamps
Requirements:
%
Forthe standardbulb failureindicator func‐
tion to work correctly,only lights bulbs must
be usedthat arethe same type and poweras
those installed during production.
#
Switch offthe interior lighting.
#
Press in catchspring of lens 1 withasuita‐
ble object e.g. ascrewdriver,and then lever
offthe lens withthe lamphousing.
#
To pull backlensfromthe lamphousing:
press thelugs of lens 2 inwards.
#
Remove light bulb 3 from thelamphousing.
#
Insertthe newlight bulb.
#
Insertthe lens in thelamphousing until it
engages.
#
Place thelens withthe lamphousing in posi‐
tion and engageit.
Light and vision
91
To Next Page
Loading...
