#
To remove: loosenscrews 1 and pull out
thetail lampinthe direction of thearrow.
#
Remove theplug from bulb mount 3.
#
Loosen screws 2 and remove bulb mount
3 from thetail lamp.
#
Gently turnthe bulb counter-clockwise and
take it out of thesocket.
#
Insert thenew bulb intothe socketand turnit
clockwise.
#
To install: setbulb mount 3 on thetail lamp
and screw in screws 2.
#
Press theplug intobulb mount 3.
#
Insertthe tail lampand screw in screws 1.
License platelamp
Requirements:
R
License platelamp: light bulb type W5W
#
Switch offthe lighting system.
#
Place ascrewdriver,for example, at opening
2 between lamp 3 and panel 1 and care‐
fullypry offlamp 3.
#
Remove lamp 3 from panel 1.
#
Rotate thebulb holder by around 45°and
detach it from thelamp.
#
Remove thelight bulb.
#
Insertthe newbulb intothe bulb holder.
#
Insertthe bulb holder intothe lampand
rotate it by around 45°.
#
Insertthe lampintothe panel opening until it
engages.
Replacing rear light bulbs(chassis)
Overviewofrear light sourcetypes (chassis)
Youcan replace thefollowing light sources.
Vehicles withstandardtail lamps
1
Clearance lamp: R5W
2
Tail light:R5W
3
Brakelight:P21W
4
Turn signal lights: PY 21 W
90
Light and vision
To Next Page
Loading...
