Friendly Robotics robomower RL800 - Page 78

3
3.2.5 Automatic Mowing Problems (con.)
3.2.5.6
23
Is there another
activated
Perimeter Switch
near the plot?
Was a ‘No wire
si
g
nal’ messa
g
e
displayed when
the Robomower
sto
pp
ed?
When does
the mower
cross the
wire?
What type of
wire did it
cross?
Robomow crosses
Perimeter Wire
(stops with ‘Start
elsewhere’
message)
Y
ES
NO
Y
ES
NO
The minimum distance
between 2 adjacent
plots activated
simultaneously should
be
g
reater than 13ft
/
4m
Is there another
adjacent plot
connected to the
same Perimeter
Switch?
NO
Y
ES
The minimum distance
between 2 adjacent
plots activated by the
same P. Switch should
be
g
reater than 5ft
/
1.5m
Is there a place
where the distance
between P. Wires
in the activated
plot is less than 5ft
/
1.5m?
 Avoid creating corners
sharper than 90 degrees in
the Perimeter Wire.
 Perform ‘Edge calibration’
 Usually a zigzagging motion
is preceding the wire
crossing (please refer to
section 5.3.2)
During
‘Scan
’
Perimeter
Island
Perimeter
Wire
 Inspect the double wires
between the Perimeter
Island and the Edge for
wire crossing or wire short
 Reinstall this part of the
wire, uncrossing them (the
wire may be cut and re-
spliced if necessary)
Too tightly pegged double
wires can cause shorts and
low Wire Sensors readings.
Double wires can be found
between:
 P. Island and P. Wire
 P. Wire and P. Switch
 Two different plots
 Refer to the setup rules
of wire placement,
particularly corners and
distances between
perimeter wires.
 Test Wire Sensors
(replace if needed)
Y
ES
The Robomow may take a
few seconds to realize that
the wire signal is missing.
Check the Perimeter Switch
Change the setup to
min. 5ft/1.5m between
2 perimeter wires in
the same plot
During
'Ed
g
e’