Fronius Robacta Reamer V Easy - Adjusting the Parting Agent Nebuliser Spray Amount

222222222
1
*
2
3
4
1
* Option (long parting agent hose)
2
22
33
11
3
Adjusting the
parting agent
nebuliser spray
amount
NOTE!
To ensure that the spray amount is adjusted properly, the welding torch must be in
the cleaning position.
1
Establish a compressed air supply to the cleaning device
2
Connect the cleaning device to the robot control
3
Start the spraying process using the robot control and check that sufficient spray is
being applied
4
If the spray amount is not sufficient, increase it as required
- by adjusting the spray time using the robot control - a spray time of ~ 0.7
seconds is recommended (nur Robacta Reamer V only)
- or by using the parting agent adjuster - see figure below
59
EN