Fronius Robacta Reamer V Easy Operating Instructions

Screwing the Robacta Reamer V Easy Han6P J to
the underlying surface
Screwing the
adjusted cleaning
device and
installation stand
to the underlying
surface
NOTE!
Different fixings may be required to set up the installation stand depending on the
type of underlying surface (foundation).
Fixings are therefore not included in the scope of supply of the installation stand. The
installer is responsible for selecting the right type of fixing.
1
Place the optional installation stand on a level, firm and vibration-free surface (found-
ation)
- Position the installation stand in such a way that the distance the robot has to
travel to the cleaning device on the installation stand is as short as possible
2
Screw the installation stand to the underlying surface (foundation) using the appro-
priate fixings
NOTE!
Use the fixings supplied with the mounting plate to fasten the mounting plate to
the installation stand.
3 4
5 6
44

Fronius Robacta Reamer V Easy Specifications

General

Brand	Fronius
Model	Robacta Reamer V Easy
Category	Welding System
Language	English