Fronius Robacta Reamer V Easy - General; Principle; Illustration of the Various Types; Device Concept - Robacta Reamer V Easy Han6 P J

General
Principle Cleaning devices from the Robacta Reamer V series are used to automatically clean
MIG/MAG welding torches. The Robacta Reamer V series cleaning devices allow you to
clean the inside and front of the gas nozzle on a wide range of welding torch shapes.
The result is a significant increase in the service life of wearing parts. At the same time,
evenly applying parting agent prevents the build-up of dirt.
Illustration of the
various types
Robacta Reamer V Easy Han6P J, Robacta Reamer V Easy, Robacta Reamer V
Device concept -
Robacta Reamer
V Easy, Robacta
Reamer V
The gas nozzle clamping device on the front of the cleaning devices holds the gas
nozzle in place during cleaning. A cleaning cutter is used to clean the nozzle. After the
cleaning process, a parting agent is applied to the inside and front of the gas nozzle
through the parting-agent injection nozzle that is fixed in the middle of the cleaning
motor.
The options available for each cleaning device are shown on the following pages.
Device concept -
Robacta Reamer
V Easy Han6P J
The gas nozzle clamping device on the front of the Robacta Reamer V Easy Han6P J
holds the gas nozzle in place during cleaning. A cleaning cutter is used to clean the
nozzle. After the cleaning process, a parting agent is applied to the inside and front of
the gas nozzle through the parting-agent injection nozzle that is fixed in the middle of the
cleaning motor.
15
EN