To Next Page

To Previous Page

CAUTION!

Danger due to cleaning cutter that has become very hot through use.

This can result in severe burns.

▶

Before handling cleaning cutters, allow cleaning cutter to cool to room temperature

(+25 °C, +77 °F).

Ensuring that the

cleaning device

is depressurised

Attempt to briefly activate the cleaning device without any compressed air supply to

check whether the cleaning device is depressurised. Proceed as follows:

Take protective measures:

- The cleaning cutter, lifting device, gas nozzle clamping device, wire cutter and

parting-agent injection nozzle could start up. Therefore keep your body, espe-

cially your hands, face and hair, any objects and all clothing away from the com-

ponents referred to above

- Wear ear protection

- Wear protective goggles with side protection

Ensure that the cleaning device has been disconnected from the compressed air

supply

Robacta Reamer V Easy and Robacta Reamer V Easy Han6P J:

Briefly turn the "Cleaning" screw on the cleaning device 90° to the right, then turn it

straight back to its original position

- If the cleaning device does not respond to the turning of the screw, the cleaning

device is depressurised

- If the cleaning device responds to the turning of the screw, the cleaning device is still

connected to a compressed air supply.

If this is the case, you must disconnect the cleaning device from the compressed air

supply and check again that the cleaning device is depressurised before starting

work

Robacta Reamer V:

Briefly turn the "Lifting device up/down" screw on the cleaning device 90° to the right,

then turn it straight back to its original position