Fronius Robacta Reamer V Easy Operating Instructions

The Robacta Reamer V Easy Han6P J also has an adjustment that works as follows:
- The manufacturer always screws all Robacta Reamer V Easy Han6P J to an adjust-
ment plate in the same position
- The Robacta Reamer V Easy Han6P J is fitted to a mounting plate at the installation
location
- Dowel pins interlock the Robacta Reamer V Easy Han6P J adjustment plate and the
mounting plate so that the Robacta Reamer V Easy Han6P J is always firmly
fastened to the mounting plate in the same position
- As a result, when a device is replaced, the robot does not have much setting up to
do. Once the device is replaced, only the motor in the lifting device of the new clean-
ing device has to be adjusted
NOTE!
The gas nozzle clamping device is adjusted for gas nozzles with an outer dia-
meter of 25 mm (0.
98 inch). If gas nozzles with a different outer diameter are used, the gas nozzle
clamping device must be adjusted before using it for the first time and each time a
device is replaced, as appropriate to the gas nozzle.
- The same system in connection with the cleaning device is also available for the
wire cutter
Components required for installing the Robacta Reamer V Easy Han6P J:
- Robacta Reamer V Easy Han6P J
- Mounting plate for the Robacta Reamer V Easy Han6P J
Components required for installing the Robacta Reamer V Easy Han6P J together
with the adjusted wire cutter:
- Robacta Reamer V Easy Han6P J
- Mounting plate for the Robacta Reamer V Easy Han6P J
- Adjusted wire cutter
- Mounting plates for the wire cutter
The options available for the cleaning device are shown on the following pages.
Applications The cleaning devices are exclusively intended for use in robot and other automated
applications, and can be used for a wide range of materials.
The main application areas are:
- Automobile and component supply industry
- Equipment construction
- Chemical plant construction
- Machine and tracked vehicle manufacturing
- Construction machinery and special vehicles
Warning notices
on the cleaning
device
The cleaning device is fitted with warning notices and a rating plate. The warning notices
and rating plate must not be removed or painted over.
The locations of the warning notices are shown on the Robacta Reamer V as an
example. The warning notices are all in the same place on the Robacta Reamer V Easy,
Robacta Reamer V Easy Han6P and Robacta Reamer V Easy Han6P J.
16

Fronius Robacta Reamer V Easy Specifications

General

Brand	Fronius
Model	Robacta Reamer V Easy
Category	Welding System
Language	English