Fronius Robacta Reamer V Easy Operating Instructions

Robacta Reamer V Easy Han6P J scope of supply,
options and required components
Robacta Reamer
V Easy Han6P J
scope of supply
(1)
(2)
(3)
(4)
(5)
NOTE!
The "Robacta Reamer" parting agent
(item number 42,0411,8042) and the
cleaning cutter are not part of the
scope of supply.
(1) Robacta Reamer V Easy Han6P J
cleaning device
(2) Spatter tray retainer
(3) Spatter tray
(4) Tightening key for cleaning motor
(5) Compressed air relief valve
not shown:
(6) Harting Han6P connecting plug (X1) without cable
(7) Operating instructions
(8) Fixings for assembling the cleaning device:
- 4 screws
Robacta Reamer
V Easy Han6P J
required compon-
ents
NOTE!
The mounting plate and fixings are not
part of the scope of supply for the
cleaning device, but are needed to
ensure that the cleaning device is
adjusted when it is installed.
Robacta Reamer
V Easy Han6P J
options
The following options are available for the cleaning device:
- Installation stand
- Suction line for canister (10 litres)
- Adjusted wire cutter
- Mounting plates for the wire cutter including fixings
21
EN

Fronius Robacta Reamer V Easy Specifications

General

Brand	Fronius
Model	Robacta Reamer V Easy
Category	Welding System
Language	English