Fronius Robacta Reamer V Easy - Robacta Reamer V Easy Han6 P J Scope, Options, and Components

23
EN
Robacta Reamer V Easy Han6P J scope of supply,
options and required components
Robacta Reamer
V Easy Han6P J
scope of supply
NOTE!
The "Robacta Reamer" parting agent
(item number 42,0411,8042) and the cle-
aning cutter are not part of the scope of
supply.
(1) Robacta Reamer V Easy Han6P J
cleaning device
(2) Spatter tray retainer
(3) Spatter tray
(4) Tightening key for cleaning motor
(5) Compressed air relief valve
not shown:
(6) Harting Han6P connecting plug (X1) without cable
(7) Operating instructions
(8) Fixings for assembling the cleaning device:
- 4 screws
Robacta Reamer
V Easy Han6P J
required compo-
nents
NOTE!
The mounting plate and fixings are not
part of the scope of supply for the clea-
ning device, but are needed to ensure
that the cleaning device is adjusted
when it is installed.
Robacta Reamer
V Easy Han6P J
options
The following options are available for the cleaning device:
- Installation stand
- Fill-level control sensor
- Adjusted wire cutter
- Mounting plates for the wire cutter including fixings
(1)
(2)
(3)
(4)
(5)