Charging lead
WARNING!
Danger from flying sparks due to improper disconnection of the charging plug.
This can result in severe personal injury and damage to property. The resulting
sparks can ignite the charging gases that form during charging and cause a fire or
explosion
▶
End the charging process via the battery charger and, after the charging
cables have cooled down, wind them up or, if available, place them on the
cable holder.
Correct installa-
tion of the
mains/charging
cables
WARNING!
Danger due to charging cables lying around.
This can result in severe personal injury and damage to property. Personnel can
get caught or trip on unplugged, loose cables.
▶
Lay charging cables so that no one can trip over them or get caught on them.
CAUTION!
Danger due to overheating as a result of incorrectly laid mains/charging cables.
Risk of damage to the mains/charging cables.
▶
The mains/charging cable may only be replaced by a qualified electrician.
▶
Lay the mains/charging cable without a loop.
▶
Do not cover the mains/charging cable.
▶
Charging cables longer than 5 m (16 ft. 4.85 in.) must be laid individually (no
bundling).
▶
Charging cables longer than 5 m (16 ft. 4.85 in.) can have an increased sur-
face temperature (be aware of hot surfaces).
▶
In the following cases, pay special attention that the surface temperature of
the charging cables does not exceed 80°C (176°F):
- Ambient temperature is 30°C (86°F) or more
- Cross-section of the charging cable is 95 mm
2
or more
- Length of the charging cable is 5 m (16 ft. 4.85 in.) or more
13
EN
To Next Page
Loading...
Need help?
General
