Display
Overview of dis-
play modes
No. Function
Standard mode
In standard mode the display shows the charging parameters.
Statistics mode
Visualises the frequency of the device operating modes and shows the
total number of charging actions. Also shows an overview of the total
and average Ah produced and energy consumed per charge.
History mode
Provides information about the parameters for all the stored charging
processes.
Configuration mode
Configuration mode enables all the settings for the device and the
charging process to be adjusted.
USB mode
USB mode enables a device to be updated, device configurations to be
saved and loaded, and the charging parameters to be recorded during
the charging process - all using a USB flash drive.
As long as a battery is connected to the battery charger, the charging process
can only be interrupted and resumed by pressing the "Pause/Start" button. It is
only possible to change the display modes with the "Menu" button after discon-
necting the battery from the battery charger. A detailed description of the dis-
play modes is given in the following chapter.
A limited menu selection is available while charging has been paused.
NOTE!
A limited menu selection is available while charging has been paused.
Standard mode Once the mains plug has been connected to the electrical mains supply, the dis-
play will automatically operate in standard mode.
In standard mode, the display shows
the following charger parameters:
-
Type of battery (e.g. Pb-WET)
-
Charging characteristic (e.g. IUI)
-
Nominal voltage (e.g. 48 V)
-
Capacity (e.g. 300 Ah)
-
Day of the week, date and time
The charger parameters can be set individually. More information can be found in
the "Configuration mode" section.
32