“Reset Settings”
-
Includes a double-check prompt ("OK?") that requires the operator to recon-
firm that this step is intended.
First the screen will appear in its initial
format, showing the date, time and
software version.
1
The "Up/Down" keys can be used to retrieve the following information:
-
Serial number of the charger plus serial number and version of the con-
figuration memory.
-
PC board for controller/power electronics: hardware version and serial
number.
-
Software: main software, secondary software, primary software and char-
acteristic block version.
The procedure for opening the configuration menu is as follows:
1
Press the "Pause/Start" key.
You will be prompted to enter a code.
The code required is "1511" and is
entered as follows:
1
Using the "Up/Down" keys, enter the first digit of the code.
2
Press the "Menu" key to move to the next digit of the code.
3
Continue following the procedure described above until the complete code
has been entered.
4
Use the "Pause/Start" key to confirm the code entered.
You will now be prompted to select
one of the main menu items for the
configuration mode.
36
To Next Page
Loading...
Need help?
General
