Charging the battery
Starting for the
first time
When the battery charger is connected to the grid for the first time, the device is
in SETUP mode.
In this mode, the following basic settings must be made or confirmed:
-
Language (English, German, French, etc.)
-
Date, time, and time zone
-
Units: metric / imperial
-
Charging cable length and charging cable cross-section
-
Type of battery, curve, number of cells, and charging time or battery capacity
1
Connect the mains plug of the battery charger to the electrical grid.
2
Use the "Up/Down" keys to select
the desired menu language.
3
Confirm with the "Pause/Start"
key.
English is set as the default language.
4
Use the "Up/Down" keys to select
the time zone.
5
Confirm with the "Pause/Start"
key.
UTC+1 Central European Time (Berlin)
is set as the default time zone.
The following settings must be made:
-
Daylight saving time ON/OFF
-
Hour format
-
Time
-
Date
6
Use the "Up/Down" buttons to se-
lect the desired setting.
7
Press the "Pause/Start" button to
confirm each setting.
Daylight saving time ON and the 24-
hour format are set as default.
8
Use the "Up/Down" buttons to se-
lect the desired setting (metric /
imperial).
9
Confirm with the "Pause/Start"
button.
26
To Next Page
Loading...
Need help?
General
