Fronius TransSteel 2700c

MIG/MAG welding, water-cooled 39
Manual metal arc welding 39
Before installation and commissioning 40
Safety 40
Utilisation for intended purpose only 40
Setup regulations 40
Mains connection 41
Connecting the mains cable 42
General 42
Stipulated mains cables and strain-relief devices 42
Safety 42
Connecting the mains cable 43
Fitting the strain-relief device, TSt 2700c, single-phase operation 43
Fitting the strain-relief device, TSt 2700c 44
Fitting the strain-relief device, TSt 2700c MV 45
Fitting the strain-relief device, TSt 3500c 46
Fitting the Canada / U S strain-relief device, TSt 3500c 47
Generator-powered operation 48
Generator-powered operation 48
Single-phase operation 49
Single-phase operation 49
Explanation of the term „duty cycle“ in single-phase operation 50
Welding time in single-phase operation 50
Fitting/connecting the system components 52
Information on system components 52
Mounting on the trolley 52
Connecting the gas cylinder 52
Connecting a MIG/MAG welding torch 53
Establishing a ground (earth) connection 54
Inserting/replacing feed rollers 54
Inserting the wirespool/basket-type spool 55
Feeding in the wire electrode 56
Setting the contact pressure 58
Adjusting the brake 59
Design of the brake 60
Start-up 61
General 61
Prerequisites 61
Commissioning 61
Welding 63
Power limitation 65
Safety function 65
MIG/MAG modes 66
General 66
2-step mode 66
4-step mode 66
Special 4-step mode 67
Spot welding 67
2-step stitch welding 68
4-step stitch welding 68
MIG/MAG welding 69
Safety 69
Overview 69
MIG/MAG standard synergic welding 70
MIG/MAG standard synergic welding 70
Corrections during welding 71
MIG/MAG standard manual welding 72
General 72
Available parameters 72
MIG/MAG standard manual welding 72
4