Fronius TransSteel 2700c

Setup menu
General remarks The Setup menu provides simple access to expert knowledge in the power source and to
additional functions. The Setup menu can be used to make simple adjustments of the
parameters to suit the various job settings.
Configuring the
setup parameters
Configuring the setup parameters is described here with reference to the "MIG/MAG
standard synergic welding" process. The procedure for changing other setup parameters
is identical.
Accessing the Setup menu
1
Use the "Process" button to select the "MIG/MAG standard syn-
ergic welding" process
2
Press and hold the "Mode" button
3
Press the "Process" button
4
Release the "Mode" and "Process" buttons
The control panel is now in the Setup menu for the "MIG/MAG standard synergic weld-
ing" process - the last setup parameter that was selected is displayed.
Changing welding parameters
1
Select the required setup parameter using the "Mode" and "Pro-
cess" buttons or the left-hand adjusting dial
2
Change the value of the setup parameter using the "Parameter
selection" buttons or the right-hand adjusting dial
Exiting the Setup menu
1
Press and hold the "Mode" button
2
Press the "Process" button
3
Release the "Mode" and "Process" buttons
81
EN