MIG/MAG modes
General
WARNING!
Operating the equipment incorrectly can cause serious injury and damage.
▶
Do not use the functions described here until you have read and completely under-
stood these Operating Instructions.
▶
Do not use the functions described here until you have fully read and understood all
of the Operating Instructions for the system components, in particular the safety
rules.
For details of the meaning, settings, setting range and units of the available welding
parameters (e.g. gas pre-flow time), please refer to the "Setup parameters" chapter.
2-step mode
"2-step mode" is suitable for
- Tacking work
- Short weld seams
- Automated and robot welding
4-step mode
66
To Next Page
Loading...
