Start-up
General
WARNING!
Operating the equipment incorrectly can cause serious injury and damage.
▶
Do not use the functions described here until you have read and completely under-
stood these Operating Instructions.
▶
Do not use the functions described here until you have fully read and understood all
of the Operating Instructions for the system components, in particular the safety
rules.
The device is started up by pressing the torch trigger (for manual applications).
Prerequisites The following conditions must be satisfied before the device is started:
- Welding torch connected
- Feed rollers inserted
- Wirespool or basket-type spool with adapter inserted
- Wire electrode fed in
- Brake adjusted
- Feed roller contact pressure set
- All covers closed, all side panels in place, all protection devices intact and in their
proper place
- Where applicable, water connections connected
Commissioning Before proceeding further as described in the "Welding mode" section, the following
activities are required for the "MIG/MAG standard synergic welding" and "MIG/MAG
standard manual welding" processes:
1
Plug in the mains plug
2
Turn the mains switch to position "I"
61
EN
To Next Page
Loading...
