TSt 2700c TSt 3500c
1
Secure the gas cylinder with a belt
2
Briefly open the gas cylinder valve to remove any dust or dirt
3
Check the seal on the pressure regulator
NOTE!
US devices (TSt 3500c only) are supplied with an adapter for the gas hose:
▶
Seal male thread spacers on the gas solenoid valve using suitable means before
screwing on the adapter.
▶
Test the adapter to ensure that it is gas-tight.
Connecting a
MIG/MAG welding
torch
NOTE!
When connecting the welding torch, check that
▶
all connections are connected properly
▶
all cables, leads and hosepacks are undamaged and correctly insulated.
1
53
EN
To Next Page
Loading...
