2-7
Mounting the covers
Put the front cover to the inverter case while fitting the edge of the front cover between the both hinges
provided on the inverter case. Slide it upward until the front cover latches.
Fit the latches on the terminal block (TB) cover in the holes provided to the front cover and push it towards
the inverter case.
Tighten the TB cover fastening screw on the terminal block (TB) cover (Tightening torque: 15.9lb-in(1.8
N·m)).
Figure 2.7 Mounting the Covers (FRN015F1S-2U)*
To Next Page
Loading...
