3-41
3.4.11 Changing function codes covered by Quick setup – "10. USER SET"
Menu #10 "USER SET" in Programming Mode allows you to change the set of function codes that are covered
by Quick setup.
Basic key operation
(1) When the inverter is powered ON, it automatically enters Running Mode. In Running Mode, press the
key to enter Programming Mode. The menu for function selection will be displayed.
(2) Select "10. USER SET" by using and keys (moving Æ).
(3) Press the
key to get the list of function codes.
(4) Select the function codes to be added or deleted, by using and
keys (moving Æ).
(5) Press the
key to perform the addition or deletion.
(6) Press the
key to return to the menu.
Figure 3.28 shows the LCD screen transition starting from the "10. USER SET" menu.
List of function codes
Lists function codes with their names.
The function codes covered by Quick setup are highlighted
(names are highlighted).
Select the function code to be added (not highlighted) by
moving the cursor with
and keys.
To go back to the menu, press
key.
Select the function code to be deleted (highlighted) by moving
the cursor with
and keys.
To go back to the menu, press
key.
Figure 3.28 Menu Transition for Changing Function Codes Covered by Quick Setup
Press key to finalize desired menu.
Press key to add it to Quick setup.
Press key to delete it from Quick setup.
/
To go back to Menu, press key.
Select desired menu by moving the pointer Æ with /
key.
To Next Page
Loading...
