2-16
Follow the procedure below for wiring and configuration of the inverter. Figure 2.12 illustrates the wiring
procedure with peripheral equipment.
Grounding terminals ( G)
Inverter output terminals (U, V, W, and G)
DC reactor connection terminals (P1 and P(+))
*
Switching connectors
*
(For the models of 208 V 50HP or above, for 460 V 75HP or above. Refer to
page 2-18.)
DC link bus terminals (P(+) and N(-))
*
Main circuit power input terminals (L1/R, L2/S and L3/T)
Auxiliary power input terminals for the control circuit (R0 and T0)
*
Auxiliary power input terminals for the fans (R1 and T1)
* (For models of 208 V 50HP or above, for 460
V 75HP or above. Refer to page 2-22.)
*
Perform wiring as necessary
Figure 2.12 Wiring Procedure for Peripheral Equipment
Wiring procedure
To Next Page
Loading...
