2-36
(2) Parts needed for connection
To mount/install a keypad on a place other than an inverter, parts listed below are needed.
Parts name Model Remarks
Extension cable (Note 1) CB-5S, CB-3S and CB-1S
3 cables available in length of 16.4ft, 9.8ft, and
3.3ft(5m, 3m, and 1m).
Fastening screw M3 ×
(Note 2) Two screws needed. Purchase off-the-shelf ones
separately.
(Note 1) When using an off-the-shelf LAN cable, use a 10BASE-T/100BASE-TX straight type cable compliant
to US ANSI TIA/EIA-568A Category 5. (Less than 66ft(20m))
Recommended LAN cable
Manufacturer: SANWA Supply Co., LTD.
Model: KB-10T5-01K (3.3ft(1m))
KB-STP-01K: (3.3ft(1m)) (Shielded LAN cable compliant to EMC Directive)
(Note 2) When mounting on an enclosure wall, use the screws fitted to the thickness of the wall.
(Refer to Figure 2.34.)
2.4.2 Mounting/installing steps
■ Mounting a keypad on the enclosure wall
Pull the keypad toward you while holding down the hook (pointed to by the arrow in Figure 2.32)
Figure 2.32 Removing a Keypad
Make a cut-out on the enclosure wall. For details, refer to Chapter 8, Section 8.5.3 “Multi-function
keypad”
Mount the Multi-function keypad onto the
enclosure with 2 screws as shown in Figure 2.33.
(Recommended tightening torque: 0.7 N･m)
Figure 2.33 Mounting Multi-function Keypad
To Next Page
Loading...
