Fuji Electric FRENIC-ECO - 3.4.1 Setting function codes - 1. Data Setting

3-14
3.4.1 Setting function codes – "1. Data Setting"
Menu #1 "Data Setting" in Programming Mode allows you to set function codes according to your needs.
Table 3.8 lists the function codes available on the FRENIC-Eco.
Table 3.8 Function Codes Available on FRENIC-Eco
Function Code Group Function Code Function Description
F code
(Fundamental functions)
F00 to F44
Fundamental
functions
Fundamental functions used in operation of the
motor
E code
(Extension terminal
functions)
E01 to E99
Terminal
functions
Functions concerning the selection of operation of
the control circuit terminals; Functions concerning
the display on the LED monitor
C code
(Control functions of
frequency)
C01 to C53
Control
functions
Functions associated with frequency settings
P code
(Motor parameters)
P01 to P99
Motor
parameters
Functions for setting up characteristics
parameters (such as capacity) of the motor
H code
(High performance
functions)
H03 to H98
High-level
functions
Highly added-value functions; Functions for
sophisticated control
J code
(Application functions)
J01 to J22
Application
functions
Functions for applications such as PID Control
y code
(Link functions)
y01 to y99
Link
functions
Functions for controlling communications
o code
(Option functions)
o27 to o59
Optional
functions
Functions for optional features (Note)
(Note) The o code is displayed only when the corresponding optional feature is installed.
For details of the o code, refer to the Instruction Manual for the corresponding optional feature.
 Function codes requiring simultaneous keying
To modify the data for function code F00 (data protection), H03 (data initialization), or H97 (clear alarm data),
simultaneous keying is needed, involving the
key + the
key, or the key + the
key.
 Modifying function code data during running; making the modification valid and saving the
modification
Some function codes can be modified while the inverter is running, whereas others cannot. Further, depending
on the function code, modifications may or may not become effective immediately. For details, refer to the
"Change when running" column in 5.1 "Function Code Tables" in Chapter 5 of the FRENIC-Eco Instruction
Manual.

For details of function codes, refer to 5.1 "Function Code Tables" in Chapter 5 of the FRENIC-Eco
Instruction Manual.
Figure 3.10 illustrates LCD screen transition for Menu item 1. DATA SET.
Figure 3.10 Screen Transition for Data Setting Menu
Menu screen
Function code list screen Screen for modifying
function code data