5 Tools
112
Tools
5
Connectivity & Network Setup
In [Connectivity & Network Setup], set the type of interface through which the machine
is connected to the client in [Port Settings], and the parameters required for
communications in [Protocol Settings].
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
For information on Network Settings, refer to "Printer Environment Settings" (P.201) or "E-mail
Environment Settings" (P.219).
When using CentreWare Internet Services, more detailed settings are possible. For more details, refer to
"CentreWare Internet Services Settings" (P.193).
The following shows the reference section for each item.
Port Settings ..............................................................................................................................112
Protocol Settings .......................................................................................................................115
Machine’s E-mail Address/Host Name.....................................................................................118
Proxy Server Settings................................................................................................................118
Outgoing/Incoming E-mail Settings .........................................................................................119
Remote Authentication/Directory Service Settings ..................................................................121
Security Settings .......................................................................................................................125
Other Settings............................................................................................................................128
1
Select [Tools].
For the method of displaying the [Tools] screen, refer to "System Settings Procedure" (P.76).
2
Select [Connectivity & Network Setup].
3
Select the item to be set or changed.
Port Settings
Set the interface by which the machine is connected to a client. In [Port Settings], you
can set the following items.
Important • For LPD, Port9100, and HTTP-SSL/TLS, do not use a number that is the same as a port
number of another port.
For a port that uses HTTP (IPP, Internet Service (HTTP), UPnP Discovery, SOAP, and
WebDAV), do not use a number that is the same as a port number of LPD, Port9100, and
HTTP-SSL/TLS.
Furthermore, if any of the above are set to one of the port numbers indicated below,
operation may no longer be performed properly depending on the setting conditions of the
port.
25, 139, 427, 445, 631, 15000
For information on HTTP-SSL/TLS port, refer to "HTTP - SSL/TLS Port Number" (P.125).
USB
îš„Port Status
Select [Enabled] to use a USB interface.
îš„Print Mode
Configure the print language on the machine to match the received data.
Select [Auto] to set the device so that it will automatically determine and use the most suitable
language to print data received from the host device.
îš„PJL
Enable when receiving a job using PJL commands.
To Next Page
Loading...
Need help?
General
