Connectivity & Network Setup
125
Tools
5
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.
Security Settings
Set the security settings.
SSL/TLS Settings
Set the SSL/TLS.
Device Certificate - Server
You can select a certificate to be linked.
HTTP - SSL/TLS Communication
Enables or disables the HTTP SSL/TLS communications.
HTTP - SSL/TLS Port Number
Specifies the port number used for HTTP SSL/TLS communication within the range from 1 to
65535.
The default value is 443.
Important • Do not use the numbers assigned to the other ports.
LDAP - SSL/TLS Communication
Enables or disables the LDAP SSL/TLS communications for LDAP authentication and
address book search by LDAP.
The port number of [Primary server port number] and [Secondary Server Port Number] for
LDAP server must be changed, if [LDAP - SSL/TLS Communication] is enabled.
The port number for SSL/TLS communications with LDAP directory server is normally 389.
Device Certificate - Client
Select a certificate to be linked.
Verify Remote Server Certificate
When the machine is to be operated as an SSL client, select whether to enable or disable a
certificate of a remote server.
S/MIME Settings
Configure the settings of S/MIME.
Device Certificate - S/MIME
Select a certificate to be linked.
For information on the certificate, refer to "Encryption and Digital Signature Settings" (P.255).
S/MIME Communication
Select whether to enable or disable the S/MIME communication.
Receive Untrusted E-mail
If you select [No], the machine does not receive the following e-mail:
z
E-mail other than e-mail sent by S/MIME when [S/MIME Communication] is activated.
z
E-mail that fails to attach a signature or verification.
z
E-mail that is attached with an expired certificate.
Receive Untrusted Internet Fax
Set whether to receive untrusted Internet Fax or not.
Message Digest Algorithm
Select a message digest algorithm. Two algorithms are available: SHA1 and MD5.
To Next Page
Loading...
