3 Maintenance
44
Maintenance
3
11
Close the Cover A tightly.
12
Close the Tray 5 (bypass).
13
Close the front cover.
Note • A message will be displayed and the machine will not operate if the front cover is not
completely closed.
Replacing the Staple Cartridge (for Finisher-A1)
When the Finisher-A1 (optional) is installed and it is time to replace the staple cartridge,
a message appears on the touch screen. When this message appears, load a new
staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may impair quality and
performance. Use only staple cartridges recommended by Fuji Xerox for the machine.
Note • To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not
operating, and open the front cover
of the finisher.
2
Take the staple cartridge out of the
finisher.
3
After removing the staple cartridge,
check the inside of the finisher for
any remaining staples.
To Next Page
Loading...
