5 Tools
168
Tools
5
Delay Start
Set whether or not to use a delayed start transmission.
If the machine’s system clock is set to the 24-hour display, [AM] and [PM] do not appear. For
information on the system clock, refer to "Time" (P.89).
Remote Mailbox
Select whether to use mailbox communications. Note that when using mailbox
communications, the other party's mailbox number and passcode must be set in advance.
1
Select [Off] or [On].
2
If you selected [On], enter a
recipient's mailbox number with the
numeric keypad, and select [Next].
3
If a passcode is set, enter the
passcode with the numeric keypad,
and select [Save].
Note • If no passcode is set, do not input anything, and select [Save].
F Code
Select whether to use F code communications.
F Code is the transmission procedure set by the Communications and Information Network
Association of Japan and is the T.30 (communication protocol) method for using sub-
addresses that are standardized by the ITU-T.
The F code (sub address) and password use not more than 20 digits 0 to 9, ∗, and #.
1
Select [Off] or [On].
2
If you selected [On], enter the F
code with the numeric keypad, and
select [Next].
Note • The F code consists of “0” + mailbox number. For example, if the mailbox number is 123, the
F code is “0123”.
3
Enter the password as required with the numeric keypad, and select [Save].
Note • You can enter up to 20 digits for the password.
Relay Broadcast
Set the instruction given to a relay station, which is used when the machine is an initiating
station and the registered address number is a relay station for relay broadcast.
When selecting [On], set [Relay Station ID], [Broadcast Recipients], and [Print at Relay
Station].
1
For a relay broadcast, select [On].
2
With the numeric keypad, enter the
two-digit relay station ID then
select [Enter/Change Recipients].
Note • The relay station ID is the
address number for the
initiating station (this machine)
already registered on the relay
station.
To Next Page
Loading...
Need help?
General
