7 Printer Environment Settings
202
Printer Environment Settings
7
Print Features Overview
This machine can be set up as a local printer by directly connecting the machine to a
computer using a USB interface cable. Similarly, it can be set up as a network printer
by connecting the machine to a network.
Enable the necessary port using the control panel or CetreWare Internet Services.
Using the Machine as a Local Printer
Use a USB interface cable to directly connect the machine to a computer.
For more information on how to set up the machine using USB connection, refer to "Installation When
Using USB Port" (P.205).
Using the Machine as a Network Printer
To set up the machine as a network printer, the following methods are available to
connect the machine.
îš„LPD
Use TCP/IP protocol when direct communication with the machine can be established.
For more information on how to set up the machine using LPD, refer to "Installation When Using TCP/
IP (LPD/Port 9100)" (P.207).
îš„NetWare
The machine supports PServer mode using Netware directory service and bindery
service. The PServer mode enables the machine to function as a printer server, and to
capture print jobs in the print queue to output. The created printer for the machine
consumes one user license of the file server.
Note • The machine does not support RPrinter (Remote Printer) mode.
• You can use the machine as a printer in a NDPS environment by using a Novell NDPS
Gateway. When using in a NDPS environment, settings of the machine to be used under a
NetWare print environment are required. Or, you need to enable LPD in advance and set it
as a gateway destination in a Novell NDPS Gateway setup. However, attribute information
that can be set or captured by NDPS is not supported.
Via Internet
IPP
Local connection
USB
Network connection
LPD/ SMB/ Port9100/ EtherTalk
Network connection
NetWare/ Windows shared printer
Server
To Next Page
Loading...
Need help?
General
