Print Features Overview
203
Printer Environment Settings
7
z
Supported interfaces
- 100BASE-TX
- 10BASE-T
z
Supported frame types
- Ethernet II specification
- IEEE802.3 specification
- IEEE802.3 / IEEE802.2 specification
- IEEE802.3 / IEEE802.2 / SNAP specification
Note • The machine sends packets of each frame type on the network, and will initialize for the
same frame type as the first reply packet received. The frame type can also be fixed.
However, if there are multiple protocols running on the same network, use Ethernet II
specification.
• Some network equipment, such as hubs, may not be compatible with the automatic frame
type detection. If a data link indicator corresponding to the port of the network equipment
connected with the machine does not light up, change the frame type settings of the
machine accordingly with that of the file server. Use CentreWare Internet Services to
change these settings.
For more information on how to set up the machine using NetWare, refer to "Installation When Using
NetWare" (P.210).
îš„SMB
Use SMB to print using Microsoft Networks.
For more information on how to set up the machine using SMB, refer to "Installation When Using
Microsoft Network (SMB)" (P.213).
îš„IPP
Use IPP to print through the Internet.
For more information on how to set up the machine using IPP, refer to "Installation When Using Internet
Printing Protocol (IPP)" (P.215).
îš„Port 9100
Use Port9100 when using Port9100 port.
For more information on how to set up the machine using Port9100, refer to "Installation When Using
TCP/IP (LPD/Port 9100)" (P.207).
îš„EtherTalk
Use EtherTalk when printing from a Macintosh computer. Adobe PostScript 3 Kit
(optional) is required.
For more information on how to set up the machine using EtherTalk, refer to "Installation When Using
EtherTalk" (P.217).
To Next Page
Loading...
Need help?
General
