5 Tools
120
Tools
5
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.
For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
POP3 Port Number
Select [Standard (110)] or [Enter Number].
Enter a port number in the range from 1 to 65535 when selecting [Enter Number].
The default value is 110.
Important • Do not use the numbers assigned to the other ports.
POP3 Polling Interval
Set the interval for checking the e-mail on the POP3 server in the range from 1 to 120
minutes, in 1 minute increments.
POP3 Login Name
Enter the name to login to the POP3 server. Up to 64 single-byte characters are allowed.
POP3 Password
Enter a password of the POP3 server. Up to 64 single-byte characters are allowed.
Using the numeric keypad displayed by pressing [Keyboard], enter the same password in
[New Password/Passcode] and [Retype Password/Passcode]. If you do not set the
password, leave the text boxes blank and select [Save].
POP Password Encryption
Select [On (APOP)] to encrypt the password.
Note • When you make an entry mistake, press the <C> (Clear) button and enter again.
• When moving to the next value without entering all 3 digits, select [Next].
SMTP Server Settings
Set the SMTP server. In [SMTP Server Settings], you can set the following items.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
• When moving to the next value without entering all 3 digits, select [Next].
SMTP Server Name/IP Address
Enter a server name or IP address. Up to 128 characters are allowed.
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.
For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
SMTP Server Port Number
Select [Standard (25)] or [Enter Number].
Enter a port number in the range from 1 to 65535 when selecting [Enter Number].
The default value is 25.
Important • Do not use the numbers assigned to the other ports.
E-mail Send Authentication
Select one from [Off], [POP before SMTP], or [SMTP AUTH].
Note • If [POP before SMTP] is selected, the POP3 settings must be set.
• AUTH PLAIN, AUTH-LOGIN, or AUTH CRAM-MD5 can be used as an authentication
method.
SMTP AUTH Login Name
Enter the user name for verification purpose at the SMTP server. Up to 64 single-byte
characters are allowed.
To Next Page
Loading...
