Fuji Xerox DocuCentre-III 2007

10 Using the Internet Fax Service
244
Using the Internet Fax Service
10
2) Select [E-mail Receive Protocol] and then select [Change Settings].
3) Select either [SMTP] or [POP3] as appropriate for your environment.
4) Select [Save], then select [Close].
If [SMTP] has been selected for [E-mail Receive Protocol]
1) Select [Outgoing/Incoming E-mail Settings].
2) Select [SMTP Server Settings] and then set the following items for the SMTP
server.
z
[SMTP Server Port Number]
Enter a value in the range from 1 to 65535.
Note • Do not use the numbers assigned to the other ports.
If [POP3] has been selected for [E-mail Receive Protocol]
1) Select [Outgoing/Incoming E-mail Settings].
2) Select [POP3 Server Settings] and set the following items for the POP3 server.
z
[POP3 Server Name/IP Address]
Enter an IP address or an server name.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
• When moving to the next value without entering all 3 digits, select [Next].
z
[POP3 Port Number]
Enter a value in the range from 1 to 65535.
Note • Do not use the numbers assigned to the other ports.
z
[POP3 Polling Interval]
Set the interval for checking e-mail on the POP3 server.
z
[POP3 Login Name]
Enter the name to login to the POP3 server.
z
[POP3 Password]
Enter the same password twice in [New Password] and [Re-enter Password]. If you
do not set the password, leave it blank and select [Save].
z
[POP Password Encryption]
Select [On (APOP)] to encrypt the password.
3) Select [Save].
4) Select [Close].
4 Configure the e-mail transmission
1) Select [SMTP Server Settings] and then set the following items for the SMTP
server.
z
[SMTP Server Name/IP Address]
Enter an IP address or a server name.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.