14 Problem Solving
372
Problem Solving
14
018-791
O [Cause] LDAP server protocol error caused by the Address Book
operation. The server returned RFC2251 Result Message
No "91" (server connection error) for Address Book query.
[Remedy] Have the network administrator check the LDAP server
status.
018-792
O [Cause] LDAP server protocol error caused by the Address Book
operation. The server returned RFC2251 Result Message
No "92" (unsupported feature) for Address Book query.
[Remedy] Have the network administrator check the LDAP server
status.
018-793
O [Cause] LDAP server protocol error caused by the Address Book
operation. The server returned RFC2251 Result Message
No "93" (no results returned) for Address Book query.
[Remedy] Have the network administrator check the LDAP server
status.
018-794
O [Cause] LDAP server protocol error caused by the Address Book
operation. The server returned RFC2251 Result Message
No "94" (no more results) for Address Book query.
[Remedy] Have the network administrator check the LDAP server
status.
018-795
O [Cause] LDAP server protocol error caused by the Address Book
operation. The server returned RFC2251 Result Message
No "95" (results remaining) for Address Book query.
[Remedy] Have the network administrator check the LDAP server
status.
018-796
O [Cause] LDAP server protocol error caused by the Address Book
operation. The server returned RFC2251 Result Message
No "96" (client loop detected) for Address Book query.
[Remedy] Have the network administrator check the LDAP server
status.
018-797
O [Cause] LDAP server protocol error caused by the Address Book
operation. The server returned RFC2251 Result Message
No "97" (referral limit exceeded) for Address Book query.
[Remedy] Have the network administrator check the LDAP server
status.
024-700
O [Cause] Required memory capacity or hard disk is not installed to
use the optional feature.
[Remedy] Turn off the power, wait until the touch screen goes dark,
and then turn on power again. If the error persists, contact
our Customer Support Center.
024-742
O [Cause] Booklet printing was specified for printer properties, but
the number of print pages for the job exceeded the
maximum number for booklet creation.
[Remedy] Change the printer properties setting to split the pages
appropriately to create separate volumes, or to cancel the
booklet setting.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
