14 Problem Solving
422
Problem Solving
14
4
After removing the staple cartridge,
check inside of the finisher for any
remaining staples.
5
Pull up the metal part of the staple
cartridge as shown in the figure.
6
Remove the jammed staples (1),
and return the metal part pulled up
in step 5 to the original position (2).
7
Return the staple cartridge to its
original position until it clicks into
place
8
Close the front cover of the finisher.
Note • If the front cover is not
completely closed, a message
will appear and the machine
will not operate.
CAUTION
Be careful in removing jammed
staples.
1
2
To Next Page
Loading...
Need help?
General
